Robot Solutionfinder [EN] Technical solutions Which type of manifold do you have?Standard unit manifoldDistrict heating manifoldLT manifoldLTV manifoldOptimum Flow manifoldHow many groups does the manifold have? (optional)In which year is the manifold purchased? (optional)Is the pump running (You can hear this very well)? (optional)YesNoIs the system properly vented? (optional)YesNoI don't knowTemperature lower temperature sensor (water supply)Temperature upper temperature sensor (return water)Heating flow temperatureAre all valves groups open? (see + and - for direction) (optional)YesNo, 1 is closedNo, 2 or more are closedWhich valve groups are closed? (optional)Where number 1 is the most left. If you have 6 groepsafsluiters you have the number 1 to 6 that can be closed.Hydraulic connection: Neutral or Active (optional)Neutral (drain on the top)Active (drain on the side)If supply and drain are sitting side by side on top of the manifold than it is a neutral installation, if the drain is on the side then it is an active installation.Did you install a plate heat exchanger? If yes, you need to hydraulic connect the manifold Active (drain on the side).YesNoWhat is the length of the tube in meters of each group? (optional)Are there deviations in the tube length of the groups? (optional)What is the diameter of the tubes from and to the central heating? (optional)Which brand appendages are being used on the manifold? (optional)SchlösserCazzanigaIs there Robot on the thermostatic?YesNoWhat is the temperature indication on the thermostatic? (Eg 20 to 50 degrees)Which brand actuator did you connect? (room control is required) (optional)RobotRemarks or further questions (optional)Name Firstname Lastname E-mail Comments (optional)This field is for validation purposes and should be left unchanged.